Reflector for photocell.

This Modem Kit will allow you to control wireless your panel (RS232 or RS485) over a distance of up to 20 km. Operating on 863-870 MHz, these modem is certified and can be used without license. Certified, the modems comply with the 2010 edition of the European Directive RTTE EN300-220.

This Modem Kit will allow you to control wireless your panel (RS232 or RS485) over a distance of up to 1 km. Operating on 863-870 MHz, these modem is certified and can be used without license. Certified, the modems comply with the 2010 edition of the European Directive RTTE EN300-220.

The new ITS CHRONO receiver photocell is much more than a simple timing accessory: it is the direct successor to the legendary TAG Heuer Timing cell, a global reference for decades. Compatible with ITS Chrono ITSPH-EM transmitters, TAG Heuer Timing HL3-000 transmitters, and all types of reflectors (HL2-112).Thanks to a built-in audible signal, alignment is a breeze and installation takes just one minute !  With this receiver photocell, you are guaranteed professional, durable equipment designed to meet the demands of high-level competition.

500mW Wireless Photocell - HL3-500 HL3-1 power supply not included   

Wireless receiver 100 mW - HL3-RX HL3-1 power supply not included   

Limited quantities. Replacement product: ITSOPTO Essential device to secure and isolate your lines in timekeeping. Meets FIS standards We recommend the use of optocoupled impulse distributors for the following reasons : Controls false triggering due to electronic interference on your timing connection wires Completely isolates your timing electronics to ensure that systems operating in parallel (back up) are not linked in any way to each other